Blog

Inicio Acerca de ZUCH Blog

2026-08-09

Ring Terminal Stud Size Guide: Choosing the Correct Hole Diameter and Tongue Width

Ring Terminal Stud Size Guide: Choosing the Correct Hole Diameter and Tongue Width When a production engineer in Suzhou released a ring-terminal drawing, she ordered parts marked for the same stud but saw the lugs foul a busbar barrier during the first fit check. Re-measuring the joint showed that the nominal stud label had hidden […]

View More
2026-08-09

MSD Connector Safety: Service Disconnect Procedures for High-Voltage Systems

MSD Connector Safety: Service Disconnect Procedures for High-Voltage Systems An MSD connector must be assessed as part of a high-voltage system, not treated as a standalone permission to carry out service work. This overview helps a buyer frame a controlled technical inquiry. Contents Define the MSD connector in the system Separate component selection from service […]

View More
2026-08-08

Energy Storage Connector Anti-Mis-Mating Design for Battery Racks

Energy Storage Connector Anti-Mis-Mating Design for Battery Racks When a rack engineer in Shenzhen replaced a module connector during a service shift, the latch appeared to close but the module failed its polarity check. The review found an orientation and replacement-part mismatch in the work process, not evidence that the connector itself was defective. This […]

View More
2026-08-08

Energy Storage Connector Creepage and Clearance: Design Rules for High Voltage

Energy Storage Connector Creepage and Clearance: Design Rules for High Voltage Use controlled application inputs and a representative validation plan before treating an interface choice as a release decision. Contents What belongs in the high-voltage design input? How should clearance be mapped? How should creepage be mapped? Why do materials and interfaces need separate review? […]

View More
2026-08-07

Waterproof Connector Cable Sealing: Grommets, Overmolding and Strain Relief Compared

Waterproof Connector Cable Sealing: Grommets, Overmolding and Strain Relief Compared Use controlled application inputs and a representative validation plan before treating an interface choice as a release decision. Contents What must a cable-sealing design define? How do grommets control the cable entry? Where does overmolding change the design review? Why is strain relief separate from […]

View More
2026-08-07

Waterproof Connector Ratings: IP67 vs IP68 vs IP69K for Industrial Equipment

Waterproof Connector Ratings: IP67 vs IP68 vs IP69K for Industrial Equipment When a maintenance engineer in Rotterdam specified a connector for a washdown cabinet, the first sample passed a component check but leaked after the cable was fitted. The visible failure looked like a bad product; the reversal was that the cable entry, mating state, […]

View More

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30