Blog

How Contact Resistance Affects Connector Performance When an automotive validation engineer in Detroit saw a low-voltage actuator fault appear after thermal cycling, a small voltage drop turned an otherwise steady signal into an intermittent one. The initial suspicion was a bad part; the investigation instead traced the fault to interface resistance shaped by terminal material, […]

Understanding EMI Shielding in Rectangular Connectors When an automation engineer in Eindhoven traced intermittent encoder faults at an industrial packaging line, the failures appeared during VFD switching: position feedback dropped out, the drive stopped, and production paused. The connector was initially blamed, but the reversal came after inspection showed a pigtail shield termination and a […]

Why Do Rectangular Power Connectors Overheat? When a maintenance engineer in Stuttgart found a cabinet feeder connector too hot to touch during a planned line restart, rapid discoloration around one termination appeared before the shift could proceed. The initial assumption was a defective connector; the investigation instead traced the heat to current demand, conductor sizing, […]

Standard Rectangular Connectors When a harness engineer in Detroit encountered intermittent power loss during an end-of-line check, she replaced a visibly damaged two-way plug and released the vehicle for a repeat test. The fault returned within minutes: a newly crimped terminal backed out as the pair was mated. The reversal was instructive—the connector was not […]

PCB Power Connector When a controls engineer in Shenzhen encountered repeated browned housings during final test of a compact pump controller, she first changed the supplier, then watched the replacement assembly warm just as quickly. The visible failure appeared within one production shift; the reversal came when the team compared the load path, conductor size, […]

PCB Connector Types When a controls engineer in Shenzhen encountered intermittent resets on a newly assembled appliance controller, she replaced the wire harness and powered the board again. Within minutes, a light pull on the cable recreated the fault: the header rocked, the contact path opened, and the controller reset. The reversal came from reviewing […]